The Lencare shower seat range is available in three sizes. They are designed to be easy to fold up and push down to open. Made with the frail, elderly and disabled in mind, the seat folds up against the wall when not in use and is easily accessed when required. The function to raise or lower the seat is an easy, soft operation. The legs & framework are made of 304 grade stainless steel. The seat component is phenolic and has in built slots to drain off the water. SE04-450, SE04-600 & SE04-960 - Tested locally to comply with a 120kg weight capacity and exceeded that target - New feature is the legs have a cross member welded into the frame, offers horizontal stability but primarily, the cross members give the installer an additional fixing point if two studs cannot be located where the legs are centred. The top and bottom braces potentially offer two more fixing points. Note, braces are not pre drilled and this will need to be done on site. - Top cross member is 50mm wide, bottom cross member is 25mm wide - The legs are now more proportionate to Australian stud positions, especially the 600mm model - SE04-450 model size - 450mm(w) x 400mm(d) - SE04-600 model size - 600mm(w) x 400mm(d) - SE04-960 model size - 960mm(w) x 400mm(d) - The height of the seat when in the opened position for all models is 480mm, from the floor to the top of the seat. - Comes with drain slots - Legs made of 304 grade stainless steel. - The original stainless steel model has a neutral seat colour, 12mm thick - A new model, matte black seat with matte black legs is available from November 2022. It has the same attributes as the original model apart from the finish.